宽带雷达中消除“盲速”的动显方法研究

Study on MTI Method of Eliminating “Blind Speed” in Wideband Radar

  • 摘要: 动目标显示雷达中通常存在多普勒频率所引起的"盲速"现象,常采用参差脉冲重复频率的方法来克服这种不利影响。在宽带雷达中,也可采用一种通过雷达回波信号的瞬时位移来检测运动目标的非相干动目标显示方法,在完全克服"盲速"影响并简化系统设计的同时,亦能够实现对包括低速目标在内的不同速度目标的有效检测。该文分别对这两种杂波抑制方法进行了研究,最后得出了宽带高分辨雷达进行杂波抑制的有效实现方法。

     

    Abstract: "Blind speed" phenomenon due to Doppler frequency usually exists in moving target indication radar. This disadvantage affect is avoided through staggered pulse repetition frequency method. In wideband radar, a noncoherent moving target indication method is adopted, which is used to detect the moving target through instantaneous displacement of radar echo signals. It not only can completely avoid the affect of "blind speed" and simplifies system design, but also can effectively detect the targets of different speed including low speed. In this paper, these two clutter suppression methods are researched, and the corresponding results of analysis are finally presented.

     

/

返回文章
返回